Is there anyway the software could be modified to allow access to options 2 and 3.
The Irish Mitsubishi FTO Owners Club
**THIS WEBSITE IS A FORUM ARCHIVE - POSTING DISABLED**
Help with software
Moderator: Moderators
4 posts
• Page 1 of 1
Help with software
by steelroe » Sat Aug 28, 2010 11:26 pm
I use the diagnostic software in the pic below.
Is there anyway the software could be modified to allow access to options 2 and 3.
Is there anyway the software could be modified to allow access to options 2 and 3.
-
steelroe - Forever Ticking Over
- Posts: 2206
- Joined: Fri Feb 28, 2003 3:14 pm
- Location: Kerry
Re: Help with software
by steelroe » Sat Aug 28, 2010 11:50 pm
Most of the files in the folder are .dbf
-
steelroe - Forever Ticking Over
- Posts: 2206
- Joined: Fri Feb 28, 2003 3:14 pm
- Location: Kerry
Re: Help with software
by CJ » Sun Aug 29, 2010 12:22 pm
The options are greyed out for a reason, whether if be related to software licence or some condition wasn't met when you launched the tool (i.e. certain files don't exist, required signal from interface not detected etc. Reverse engineering something like this would be tricky and would require a full understanding of the application and the protocol in use and knowledge of the language the application was written in. Do you know any software engineers or technical architects?
CJ
CJ
-
CJ - Site Admin
- Posts: 9083
- Joined: Mon Feb 24, 2003 4:44 pm
- Location: Dublin 15
Re: Help with software
by steelroe » Sun Aug 29, 2010 2:52 pm
CJ wrote: Do you know any software engineers or technical architects?CJ
Wish i did, could really do with this one.
-
steelroe - Forever Ticking Over
- Posts: 2206
- Joined: Fri Feb 28, 2003 3:14 pm
- Location: Kerry
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest