WANTED: GX/GR Exhaust midsection or catback exhaust

[Temeeo]

I'm looking for GX/GR exhaust midsection in decent condition mine is about to break into two and is letting fumes into interior. Alternatively I would consider entire catback if somebody had one for sale (stainless)?

[goz_83]

Could be a good time to upgrade? Might even cost you less.

[mivecrx]

If your interested in getting a stainless one made, my mate can do it. Proper mandrel bent systems!, best exhaust you can buy.

Pm me if you want.

[mivecrx]

Forgot to say he can just make a replica of you midsection if you not into upgrade system. Be factory like only stainless.

[Temeeo]

Exhaust upgrade was on cards but not so soon as there are other bits that I wanted to get sorted first...

[brccrx]

Post pics of the damage, maybe we should go at it when doing the clutch? Im very good at welding and have mig welder here, just buy wire for it that'll do

[Temeeo]

Sadly I think this puppy is beyond saving, don't think there is much left there to weld Seb. There used to be exhaust repair putty sitting over the section but that has now fallen off and revealed the extend of the damage. I would say if I poke into it there would be a two inch gap between the muffler and the pipe that goes to back box...

[brccrx]

Measure how long is the whole silencer including 100mm excess for the rotten part of the pipe and get this:

http://www.ebay.ie/itm/STAINLESS-STEEL- ... Sw3ydV0eKr

or if its more than 250mm go for this:

http://www.ebay.ie/itm/2-5-Exhaust-Tube ... xykMpTJDhI

or this? lol

http://www.ebay.ie/itm/63-5mm-2-5-STAIN ... Sw1x1URPU2

or mild steel if you plan to upgrade exhaust next year or 2 years?

http://www.ebay.ie/itm/60mm-2-5-Univers ... XQ8OdRJifb

[Temeeo]

That's handy that that you can get small quantities like that! Did a little job on it yesterday and it's better than new now! Only kidding, but at leat I can drive the car now without fumes getting inside and fear that it's going to snap in two!



Pretty!



While I was under the car I discovered another hole so patch it up as well

[mivecrx]

Nearly be as good as a poor weld