The Irish Mitsubishi FTO Owners Club

Anyone know if there is a supplier of these alloys in ireland?

try these lads..

http://www.eastcoastalloys.com/

can't be 100% but that's where I'd start.

i saw a set on ebay before I was considering and they gave me a P&P cost to Ireland. Not too expensive either IIRC. Didnt go with them in the end but its actually BK you'd be buying off so i cant see a problem.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0069571781

I know they're not an Irish Supplier but cost ways it really wasnt bad.

My sis's fella knows Brent in East Coast Alloys. I have bought a couple of sets of alloys and got tyres there and I've found him to be fairly reasonable. I do get a bit of a discount as my sis's fella sends loads of lads to him to buy bits and pieces, as a result he gets a discount on his own purchases (ie mine as well ) If you want I could ask him to get a price for you. I would need the alloy name,size, car its going on to (I assume the FTO) and what make and size tyres you want. But I think if you can buy direct from BK it might be cheaper that way.

Thanks lads for the replys and for the offer karl,
Think lll go thru ter main site

Tryed the ebay link and got a reply of 475pound all in delieverd for a set of silver 299s

Then when thru the main site itself and got cheaper again with extra bits

BK299 Alloy Wheel Package
Code: BK299171011035
4 Wheels ready fitted with tyres
Colour: Silver
Size: 7 x 17
Holes: 10
PCD: 110114
ET: 35
Nuts/Bolts and Spigot Rings included
Locking Nuts pack of 4
Chrome upgrade Valves

Can anyone confirm that these will fit my car?


Thanks
Jay

jayod12b wrote:......Size: 7 x 17
Holes: 10
PCD: 110114
ET: 35
Nuts/Bolts and Spigot Rings included
Locking Nuts pack of 4
Chrome upgrade Valves

Can anyone confirm that these will fit my car?


Thanks
Jay

The PCD is not clear from above measurements - PCD for an FTO should read 114.3 x 5.

Nuts and Spigot rings (67.1 bore) should also be correct for FTO.

What tyres are they offering in this package? As this was a subject of much debate in the technical forum, subtject "tyre advice". you may well be able to specify the tyres you want all be it at extra cost.

set of BK's of an FTO here ->>
http://www.ftooc.org/phpbb/viewtopic.php?t=98692

Myfeckin FTO wrote:The PCD is not clear from above measurements - PCD for an FTO should read 114.3 x 5.

Nuts and Spigot rings (67.1 bore) should also be correct for FTO.

PCD seems to be 110 and 114mm, multi fitment.

I'd be more concerned about the centre bore fitment being right.

colm_mcm wrote:...........
I'd be more concerned about the centre bore fitment being right.

No biggy really - they're aftermarket alloys so they're manufactured with a large bore and should include relevantly sized spiggot rings according to spec of car.

ah these are new alloys