Dragonheart wrote:Correct me if I'm wrong but can a car not be driven to a dyno without being put on the back of a truck??
the car has no map.
It runs all the 365cc injectors under the same load as the 125 the fto has so its overfueling HUGELY,
the ECU thinks its a standard GPX and treats everything the same.
so when the car idles at 12% load on standard injectors it uses 90cc of fuel its now sending 262.8cc
not to mention the huge amount of extra airflow.
if i attempted to drive the car from moate to TDP i would melt the pistons in notime at all.
The flames would be cool but sending the injectors through the bonnet would be a bit of a pain.
The driver side wheel bearing is shot but i havnt noticed as the car hasnt driven vary far at all since its completion.
Iv been advised to do yet a more comprehensive wire tuck and plumbing relocation.
On top of replace the wheel bearing. should be back up with TDP by the end of the month.
as its cost me 360 euro to be told go home and fix what I needed.
Here is the fruits of my wire tuck.
your looking more around where the turbo is and up and down pipes. wires removed along with hoses re-routed.
BEFOREAFTER