Tomeck was kind enough to drop some red tint film over to me during the week, I fitted it during the week. Fitting is reasonably straightforward:
After removing the light units, I washed them with soapy water and stuck them on the radiator to dry / heat up. I removed the raised writing with a sharp Stanley blade in advance. I didn't need to use the hairdryer on the film until I got to the angled section of the reverse light, it can be a bit tricky to get the film to fit, some persausion and adequate heat is required. I did get some air bubbles, I later removed them by using the blade to prick the surface and then pushed the air out by hand. After trimming around the sides with the blade, I used more heat to cure the film to avoid peeling.
I'm very happy with the result, its pretty seamless looking and really suits a red FTO in terms of providing a more blended look at the rear. The only downside is the indicators flash red, as do the reverse lights (a lot more so than if you used tint spray). With respect to the NCT, I would bear this in mind if you're considering this mod (this shouldn't be an issue with black tint film). Luminosity levels remain unaffected.
Lights offLights onLights off (close-up)Lights on (close-up)CJ