Page 1 of 1

Great idea

PostPosted: Thu Jun 22, 2006 4:40 pm
by CJ
Check out the oil drain valves on http://www.fumotovalve.com/, I'll defo be getting one for the Rex (oil change every 4k kms :roll: ) to make life easier, I don't know if they would suit the oil pan on a lowered FTO though, I'd be a bit concerned that a rock or similar woul knock the valve off the pan, that said, I suppose it could happen on any car.

Its refereshing to see a simple little product that makes life that bit easier.

CJ

Use discount code YM4 if you decide to order one....

PostPosted: Fri Jun 23, 2006 12:18 am
by JD
Certainly looks like a great idea, and idea which one would fit the FTO?
JD

PostPosted: Fri Jun 23, 2006 9:16 am
by JayVersion"R"
Real genius, i'll be getting one of those.

PostPosted: Mon Nov 06, 2006 10:40 pm
by JD
Got one of these last week (the F106), total cost was just under €23. Went on no problem,

It doesnt stick down much at all (see pic), it points more to the back than the ground, so there shouldn't be a problem with a lowered fto (mine isn't). The little lever is on the opposite side to the picture.

...roll on the next oil change!!!

Image

PostPosted: Tue Nov 07, 2006 9:12 am
by CJ
Good man JD, I've yet to install mine in the FTO but I did throw one onto the RX-7 and I gotta say it beats fishing around in a bucket of oil for a sump plug!

CJ